Now you can navigate back to the USB drive. Step 4: Flashing the ControllerĪgain, boot the server to the UEFI shell. Now that this is complete, you should remove the J6 jumper installed on Step 2. The process will take a minute or two to complete. Sas3flash.efi -f SAS9300_8i_IT.bin -noreset UEFI LSI SAS 3008 Reset Adapter If you took a picture of the SAS address sticker, you may not need this. Note the SAS Address as we will use it later. If it does not, we may suggest using your smartphone for a quick picture as noted in Step 2. That will give you output similar to the following. You will likely want to note the SAS address first. Once in the UEFI shell you will change to the USB drive (in our case “fs1:”). Most major manufacturers include this option in their BIOS boot menu. Step 3: Booting the Server and Resetting the Adapterīoot the server you are using to an UEFI shell. Although we are going to need to access it again, ensure that it has proper cooling. Example LSI SAS3008 SAS Address StickerĪfter this is in place, take the controller and place it in the motherboard. We will show another way to get the SAS address but this is useful in the event you forget it later. One other tip we have is to use your mobile phone to take a picture of the SAS Address sticker usually located on the rear of the card. Here is the jumper you need to connect: IBM M1215 LSI SAS3008 HBA Jumper On And Off The first step we need to do is to put a jumper on J6 we want to reset the firmware and ensure we have a successful flash. You can also rename sas3flsh.efi to sas3flash.efi if you want to follow the below exactly. You should also be able to utilize tab autocompletion after “sas3f” which will make that difference moot. Please note, if you have sas3flsh.efi instead of sas3flash.efi remove the “a” from the following commands. Place that USB thumb drive in a USB port of the server you will use to flash. We are going to use an UEFI shell to perform the flash so there is no need to use a DOS boot disk. Take these three files and copy them to a USB thumb drive.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |